Re: Akura ADV14S


[ Other Replys ] [ Reply to this message ] [ Return to Discussion Forum ]
Posted by Melanie on December 11, 19103 at 10:21:01:

In Reply to: Re: Akura ADV14S posted by jim hancock on November 27, 19103 at 03:53:35:

Hi

You should be able to select the output as PAL only I believe - haven't got the manual with me but I think if you have a look you should be able to. If that still doesn't do it then have you got a cheap scart lead? I don't know why, but you need all 21-pins of the scart connected to display NTSC in colour. I don't think all cheap leads are fully connected.

Hope this helps,
Melanie

: : This hack worked fine except I have a B&W picture with NTSC/Region 1 DVDs. Any ideas? It's a Sharp TV. / Jim

: : : 1. In the no disc mode (i.e when the player is powered on without a disc)
: : : 2. press the setup key on the remote
: : : 3. then press the following key in order
: : : 4. vol + , vol - , vol + , vol – (these are the buttons marked + & - that are under the audio key on the remote)
: : : 5. when you have press these button your display should read region 2 in the top left on the screen.
: : : 6. then use the right key (the blue right button in the middle of the remote) until the 2 in the top left of the screen reads 255 (the numbers 1 to 6 are the different regions and 255 is multi region)
: : : 7. when 255 is highlighted then press the return key on your remote and then press the menu button which should take you to the the no disc mode
: : : 8. now you player is region free (and remember this is a one of hack and will never need to be repeated)


Other Replys



Name:

E-Mail:

(optional)

Subject:

Message: